%ERR-1-GT64010: Fatal error, PCI Master abort

Unanswered Question
Jul 25th, 2008
User Badges:

I get this error message during the boot:

Smart Init is disabled. IOMEM set to: 15

Using iomem percentage: 15

Error, PCMCIA vendor/id incorrect, 0xFFFFFFFF

%ERR-1-GT64010: Fatal error, PCI Master abort

cause=0x0300E483, mask=0x0CD01F00, real_cause=0x00000400

bus_err_high=0x00000000, bus_err_low=0x31000000, addr_decode_err=0x1FE0000E


It doesn't look to cause any problems for the router.


The error message came after I did this. I configured the router with reference to an IOS file which does not exist. The router was not able to boot normal anymore, so I deleted the configuration from ROM mode.


It is a Cisco 3600 router with PCMCIA card slots which is not used.


I have not found a solution to get rid of the message.




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
lgijssel Fri, 07/25/2008 - 01:14
User Badges:
  • Red, 2250 points or more

You may not be using the PCMCIA slots (anymore) but perhaps there is still a card in one of them?

If so, remove it and retry the boot.

Otherwise, it may be a hardware problem with the PCMCIA interface or a softwareproblem.

If using several alternative IOS versions does not change anything about the message you may start suspecting the hardware.


regards,

Leo

janhagencisco Fri, 07/25/2008 - 02:40
User Badges:

Thank you for the help, I do not use the PCMCIA slot and will not used it at all. There is no cards in the PCMCIA slot.

Actions

This Discussion