07-26-2008 11:51 AM - edited 03-11-2019 06:20 AM
Hello everybody
I have PIX 501 conected a modem where i configured a vpn, I created a vpngroup and I give all the permission, I can connect across the vpn but my problem is that I can't to ping the pix and inside network.
I used the command split tunneling and nonat for the VPN's ip.
Regards,
Solved! Go to Solution.
07-28-2008 11:03 AM
Please do the following:
1) Try to enable NAT-T
isakmp nat-traversal
2) Try to change your split-tunnel ACL from extended to standard.
Regards
Farrukh
07-26-2008 05:26 PM
if the software before version 7
try to make fixup icmp
if 7 or above
make the inspect icmp icmp
inspect icmp error
under the global_inspection rule
also add ACLs to allow the icmp between VPN IPS and whatever u want
Rate if helpful
07-26-2008 09:56 PM
Is traffic besides ICMP working? If it is, enable ICMP inspection.
Else check the routing, crypto ACLs, split tunnel configs/routers, NAT exemption etc.
Regards
Farrukh
07-28-2008 06:16 AM
Hi again, thanks for you help friends, I enabled the fixup snmp error, but I still can't connect to inside network, I attached the sho ver and the sho run, I am connect with the pix through PDM. (El pix even can't to ping the remote site)
Thanks a lot (sorry for my english).
Regards,
07-28-2008 06:24 AM
07-28-2008 11:03 AM
Please do the following:
1) Try to enable NAT-T
isakmp nat-traversal
2) Try to change your split-tunnel ACL from extended to standard.
Regards
Farrukh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide