ah ok..going to tried that...

and can i use this dot also for my translation-profile ?

because my phonenumber is 100

and how does it look like then (the translation-profile?)

Thanks

what you wanna achive with the translation profile?

and what numbers you have ?

post the details to let me help you ok

Hi,

I have an analoge line with number 0101234567

for example..

however this number is ending at 567 and my number internal is 100

so if we can match with the dot its not letting number 100 to ring

So thats wy i think we also need a translation-profile that is pointing the dot to 100

But..perhaps can you also give me the complete incoming dial-peer that would be great!

so the only thing i want to do is let the phone ring when someone is calling the external number.

hope you can help me..

Gr

the following config will take any number coming the port such as 0/0/1 ISDN and change the called number to 100

so if u have a dial-peer for a number 100

such as pots for analog phon or voip

the call will be forwarded to that dial-peer

Voice translation-rule 1

Rule 1 /.*/ /100/

Voice translation-profile profile1

Translated called 1

Dial-peer voice 9 pots

Incoming called-number .

direct-inward-dial

translation-profile incoming profile1

port 0/0/1

forward-digits all

but if you have FXO ( which your case FXO i think)

just put the following command under the FXO port

and it will forward the call to the number 100

voice-port 1/0/0

connection plar opx 100

PSTN calls arriving on the FXO port can now terminate on extension 100

(replace the port 1/0/0 with your own port )

any try it and let me know

focus on this one:

just put the following command under the FXO port

and it will forward the call to the number 100

voice-port 1/0/0

connection plar opx 100

PSTN calls arriving on the FXO port can now terminate on extension 100

(replace the port 1/0/0 with your own port )

dont forget to make pots dial-peer for ur analog phone such as

dial-peer voice 3 pots

destination-pattren 100

port 1/0/1

where the port is ur FXS analog phone port

let me know if its worked or not

Great!!!

The last config worked..

with the plax connection...

the dial-peer incoming didn't worked..

so this is then very easy with only one command...

however normally the dial-peer must work but then we need a number to match...but tis is great... thank you...

i confused first time

with FXO only the command i have given you work

but if u have trunk or an ISDN link then the incoming dial-peer condig should be use

any way i am glad its working

please Rate the helpful post

and good luck

Yep...great..

thank you for your help..

and i rate you reply...

Thanks