How to elect SUP module as a active by manual configuration.

Unanswered Question
Jul 27th, 2008

Hi, all.

I am struggling that if SUP engine can be configured as a active with manual configuration.

If I equipped two engines, SUP automatically decide to elect a active module. But I want to know which slot is higher between two slots.

And how can i control one SUP is active and other SUP is standby.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Mark Yeates Sun, 07/27/2008 - 17:37

I don't believe there is a way to configure a specific supervisor to be "active" when the switch boots up. When the switch boots up whichever supervisor boots first typically will be the active supervisor.

HTH,

Mark

Actions

This Discussion