How to elect SUP module as a active by manual configuration.

jsnoh0228 · ‎07-27-2008

Hi, all.

I am struggling that if SUP engine can be configured as a active with manual configuration.

If I equipped two engines, SUP automatically decide to elect a active module. But I want to know which slot is higher between two slots.

And how can i control one SUP is active and other SUP is standby.

Thanks

Mark Yeates · ‎07-27-2008

I don't believe there is a way to configure a specific supervisor to be "active" when the switch boots up. When the switch boots up whichever supervisor boots first typically will be the active supervisor.

HTH,

Mark