unable to configure ssh on my cisco 2851

donnie · ‎07-27-2008

Hi all. I have a cisco 2851 with ios 12.4. I would like to configure ssh as a form of remote access to my router. However it seems there is no ssh option as shown below. Is it possible to configure ssh on cisco 2851? Thks in advance.

RT01CA(config)#line vty 0 4

RT01CA(config-line)#transport input ?

all All protocols

lapb-ta LAPB Terminal Adapter

mop DEC MOP Remote Console Protocol

none No protocols

pad X.3 PAD

rlogin Unix rlogin protocol

telnet TCP/IP Telnet protocol

udptn UDPTN async via UDP protocol

v120 Async over ISDN

senthuran · ‎07-27-2008

yes,its possible to have ssh access on cisco 2851 provided you have encryption image - image name with K9 installed.

dhananjoy chowdhury · ‎07-27-2008

do a sh ver and check the IOS has "K9"

something like this....

Router#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C1700 Software (C1700-K9O3SY7-M), Version 12.3(19), RELEASE SOFTWARE (fc2)

___________________________

Advanced Security-Addon to the IP base image provides you support for Cisco IOS FW, IDS/IDP, NAC, SSH/SSL, IPsec VPN, etc.

donnie · ‎07-30-2008

Hi,

Sorry for the late reply, below is the output when i do a sh ver. Can i confirm if there is no K9 image in my ios?

Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(3i), RELEASE

SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Compiled Wed 28-Nov-07 21:09 by stshen

ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)

RT01CA uptime is 1 week, 5 days, 4 hours, 45 minutes

System returned to ROM by power-on

System image file is "flash:c2800nm-ipbase-mz.124-3i.bin"

Cisco 2851 (revision 53.50) with 251904K/10240K bytes of memory.

Processor board ID FCZ121471LR

2 Gigabit Ethernet interfaces

6 Serial interfaces

6 Channelized T1/PRI ports

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

Edison Ortiz · ‎07-30-2008

You are running an IP Base image w/o security, thus no K9 for SSH support.

__

Edison.

donnie · ‎07-30-2008

Hi. Can you advise on how i can download this image? Do i need a cisco cco id? Thks in advance.

senthuran · ‎07-30-2008

You need cco id to download the IOS.

If you dont have a software contract,Your best bet may be to contact a Cisco sales rep and ask how you can obtain a licensed copy of the IOS you need