07-28-2008 04:39 AM - edited 03-15-2019 12:13 PM
Hi!
I am trying to use a NM-HDA-4FXS module, installed into a 2811 ISR, as a set of SCCP devices with CUCM 6.1. Unfortunately, in the gateway configuration menu I cannot select neccessary type of module, that is installed into Slot 1. There is only NM-HDV2 and NM-HD's. Although, all manuals are saying, that NM-HDA-4FXS is supported.
Somebody has met such problem?
Solved! Go to Solution.
07-29-2008 08:20 AM
Hi Dennis,
You are right and I am sorry about the wrong post, I was checking the 2800 Series data sheet and the NM-HDA-4FXS is supported on the 2811:
However, the problem here is that the NM-HDA-4FXS module does not supports SCCP:
#
These are supported:
* VoIP H.323, VoIP session initiation protocol (SIP), and VoIP Media Gateway Control Protocol (MGCP) with Call Agent
* Voice over Frame Relay (VoFR)
* Voice over ATM (VoATM)
* VoATM adaptation layer 5 (VoAAL5)
* Trunked ATM adaptation layer 2 (AAL2)
#
VoIP H.323 and MGCP with Cisco CallManager are supported.
Here is the link:
http://www.cisco.com/en/US/products/hw/modules/ps2617/products_tech_note09186a0080094aba.shtml
I have tested the 2811 with NM-HDA-4FXS on CUCM 6.1.2 and it is listed there. I was able to register this endpoint by using MGCP.
Hope it helps!
07-28-2008 04:21 PM
Hello Denis,
Unfortunately, the NM-HDA-4FXS module is not supported on the 2811 gateway. It is only supported on the 2821, 2851, 3825, and 3845 models.
Below you will find the NM-HDA-4FXS data sheet:
Hope this helps!!!
07-28-2008 10:30 PM
Hello, Esteban!
Thank you for your reply, but NM-HDA-4FXS IS supported on the 2811 platform. The datasheet, link to which you gave, is regarding EVM-HD module.
07-29-2008 08:20 AM
Hi Dennis,
You are right and I am sorry about the wrong post, I was checking the 2800 Series data sheet and the NM-HDA-4FXS is supported on the 2811:
However, the problem here is that the NM-HDA-4FXS module does not supports SCCP:
#
These are supported:
* VoIP H.323, VoIP session initiation protocol (SIP), and VoIP Media Gateway Control Protocol (MGCP) with Call Agent
* Voice over Frame Relay (VoFR)
* Voice over ATM (VoATM)
* VoATM adaptation layer 5 (VoAAL5)
* Trunked ATM adaptation layer 2 (AAL2)
#
VoIP H.323 and MGCP with Cisco CallManager are supported.
Here is the link:
http://www.cisco.com/en/US/products/hw/modules/ps2617/products_tech_note09186a0080094aba.shtml
I have tested the 2811 with NM-HDA-4FXS on CUCM 6.1.2 and it is listed there. I was able to register this endpoint by using MGCP.
Hope it helps!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: