Error in AP1250

Unanswered Question
Jul 29th, 2008

Hi,

I have installed an AP 1250 , i would like to check whether the device will support 802.11 A ,G Series Adapter

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
slapham Wed, 07/30/2008 - 20:40

When you say 802.11 A,G Adapter, or you saying for the client? What kind of error are you getting?

ignatiusrajkumar Wed, 07/30/2008 - 21:06

Hi,

The error I have faced after installation of AP 1250 was releated to the Client adapter.

My doubt whether my client adapter which is in 802.11 a /b/g will support AP 1250 which is in 802.11 n.

slapham Wed, 07/30/2008 - 21:13

Would the client not associate to the AP? Does the AP see the client trying to associate? In a nutshell, 802.11n just aggregates multiple a or g radios. The 802.11n is also an a/b/g radio. If this is a new install, I would check to make sure you have enabled the radios as the radios are disabled from the factory. I hope this helps...

ignatiusrajkumar Sat, 08/02/2008 - 02:59

Hi Slapham,

Thanks for your feedback,there was a problem

at the Client Interface and hence the association did not take place with the AP the same was taken care, Thanks for your support.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode