07-29-2008 01:17 AM - edited 07-03-2021 04:14 PM
Hi,
I have installed an AP 1250 , i would like to check whether the device will support 802.11 A ,G Series Adapter
07-30-2008 08:40 PM
When you say 802.11 A,G Adapter, or you saying for the client? What kind of error are you getting?
07-30-2008 09:06 PM
Hi,
The error I have faced after installation of AP 1250 was releated to the Client adapter.
My doubt whether my client adapter which is in 802.11 a /b/g will support AP 1250 which is in 802.11 n.
07-30-2008 09:13 PM
Would the client not associate to the AP? Does the AP see the client trying to associate? In a nutshell, 802.11n just aggregates multiple a or g radios. The 802.11n is also an a/b/g radio. If this is a new install, I would check to make sure you have enabled the radios as the radios are disabled from the factory. I hope this helps...
08-02-2008 02:59 AM
Hi Slapham,
Thanks for your feedback,there was a problem
at the Client Interface and hence the association did not take place with the AP the same was taken care, Thanks for your support.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide