QOS configuration error

a.rooprao · ‎07-29-2008

Presently I am using the below IOS in my 7600 router

c7600rsp72043-advipservicesk9-mz.122-33.SRC1.bin

In qos configuration i am getting the following error

-------------------------------------------

------class-map match-all ILL

match access-group name ILL

class-map match-all UNCAP

match access-group name test5

policy-map Child

class UNCAP

police 10000

policy-map Parent

class ILL

service-policy Child

HFCL-GW-2#

HFCL-GW-2#conf terminal

Enter configuration commands, one per line. End with CNTL/Z.

HFCL-GW-2(config)#

HFCL-GW-2(config)#int gigabitEthernet 1/9

HFCL-GW-2(config-if)#service-policy input Parent

Hierarchical policymap is not supported for this interface. Configuration failed

!

HFCL-GW-2(config-if)#

-------------------

rajib_das · ‎07-29-2008

Hierarchical policymap is not supported in Cisco

7600 router with image c7600rsp72043-advipservicesk9-mz.122-33.SRC1.bin

regards

Rajib

a.rooprao · ‎07-29-2008

pl let me know the ios name where it can suooprt

supporting data sheet also

a.rooprao · ‎07-29-2008

Can any one help me on this

Pl can you share any doc on this

a.rooprao · ‎07-31-2008

Pl help on this case.

Joseph W. Doherty · ‎07-31-2008

6500/7600 QoS support for LAN interfaces is often not as extensive as the support for some WAN interfaces or what the "software" routers support. However, with what you're trying, you might need a shaper within the parent's class (unsure though). E.g.

policy-map Parent

class ILL

service-policy Child

shaper average ####

Again, unsure whether the above will help, but you might try it.

Also, from what you're posted, something like:

class-map match-all ILL_n_UNCAP

match access-group name ILL

match access-group name test5

policy-map SinglePolicy

class ILL_n_UNCAP

police 10000

Might work.