3745 router does not accept any key input

Answered Question

I have a 3745 router that boots, displays all the boot information while booting, but after it boots and says "Press Return to get started" it dos not accept any keyboard input.

I wanted to try to boot the router in ROMMON mode to see if the baud rate is mismatched, but I am not able to use "CTRL +Break" to go into rommon.

I have removed all cards from it and it only has CISCO3745-IO-2FE blade.


I have this problem too.
0 votes
Correct Answer by Giuseppe Larosa about 8 years 2 months ago

Hello joel,


9600 baud rate

8 bit

1 bit stop

no parity

flow control xon/xoff

verify the cable on another cisco device

have the console before powering up the router

see also


Hope to help


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)


This Discussion