HSRP between 2 ports on the same router (3825)

Unanswered Question

Can I configure HSRP to run between two ports on the same router? I want to implement port level Layer 3 redundancy. Typically this is done using two different routers (better) but we have a single router. I have 2 HWIC-1FE ports that will be connected to the same network. I want the devices at the other end to have a single virtual IP to point to so that when a port fails on the 3825 a new active port is elected and traffic continues to flow. I've been told that HSRP will only run on 2 or more routers.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Tue, 07/29/2008 - 11:40
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello,

you cannot use HSRP on two interfaces of a single router because you cannot put on them IP addresses of the same IP subent

you will get an error

adddress overlapping with ...


you can use IRB for this


bridge 1 route ip


int bvi1

ip address x.x.x.x y.y.y.y


int fas0/1

no ip address

bridge-group 1

int fas0/2

no ip address

bridge-group 1


this should give you redundancy with a single router


Hope to help

Giuseppe

Actions

This Discussion