Destination NAT

Unanswered Question
Jul 31st, 2008
User Badges:

All,


I need to be able to NAT to specific addresses on a destination basis. As you can see from my config below I have created a pool (POOL_1) and created a NAT statement that says... NAT traffic that matches the ACL 100 to an address in POOL_1. However, it doesnt seem to work, when I try to establish a connection I do not see any output from 'show ip nat translation'...am I missing something??


My Config...


interface FastEthernet0/0

ip nat outside


interface FastEthernet0/1

ip nat inside



ip nat pool POOL_1 192.168.178.42 192.168.178.45 netmask 255.255.255.248 type rotary


ip nat inside destination list 100 pool POOL_1


access-list 100 permit ip 10.1.1.1 0.0.0.255 host 192.168.80.19



Thanks in advance for any help


Steve


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Thu, 07/31/2008 - 03:23
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Steve


Is that meant to be 10.1.1.0 0.0.0.255 rather than 10.1.1.1 that you have ?


Jon

AxiomConsulting Thu, 07/31/2008 - 03:24
User Badges:

yeah sorry, my typo....



access-list 100 permit ip 10.1.1.0 0.0.0.255 host 192.168.80.19

Richard Burts Thu, 07/31/2008 - 07:09
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Steve


Thanks for posting back to the forum and indicating that you have found a solution and what the solution is. It makes the forum more useful when people can read about a problem and can read what solved the problem.


The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.


HTH


Rick

Actions

This Discussion