07-31-2008 03:17 AM - edited 03-06-2019 12:32 AM
All,
I need to be able to NAT to specific addresses on a destination basis. As you can see from my config below I have created a pool (POOL_1) and created a NAT statement that says... NAT traffic that matches the ACL 100 to an address in POOL_1. However, it doesnt seem to work, when I try to establish a connection I do not see any output from 'show ip nat translation'...am I missing something??
My Config...
interface FastEthernet0/0
ip nat outside
interface FastEthernet0/1
ip nat inside
ip nat pool POOL_1 192.168.178.42 192.168.178.45 netmask 255.255.255.248 type rotary
ip nat inside destination list 100 pool POOL_1
access-list 100 permit ip 10.1.1.1 0.0.0.255 host 192.168.80.19
Thanks in advance for any help
Steve
07-31-2008 03:23 AM
Steve
Is that meant to be 10.1.1.0 0.0.0.255 rather than 10.1.1.1 that you have ?
Jon
07-31-2008 03:24 AM
yeah sorry, my typo....
access-list 100 permit ip 10.1.1.0 0.0.0.255 host 192.168.80.19
07-31-2008 06:11 AM
Just to let you know that I solved the problem using route-maps....
http://www.cisco.com/en/US/docs/ios/12_2t/12_2t4/feature/guide/ftnatrt.html
Thanks
Steve
07-31-2008 07:09 AM
Steve
Thanks for posting back to the forum and indicating that you have found a solution and what the solution is. It makes the forum more useful when people can read about a problem and can read what solved the problem.
The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide