07-31-2008 03:17 AM - edited 03-06-2019 12:32 AM
All,
I need to be able to NAT to specific addresses on a destination basis. As you can see from my config below I have created a pool (POOL_1) and created a NAT statement that says... NAT traffic that matches the ACL 100 to an address in POOL_1. However, it doesnt seem to work, when I try to establish a connection I do not see any output from 'show ip nat translation'...am I missing something??
My Config...
interface FastEthernet0/0
ip nat outside
interface FastEthernet0/1
ip nat inside
ip nat pool POOL_1 192.168.178.42 192.168.178.45 netmask 255.255.255.248 type rotary
ip nat inside destination list 100 pool POOL_1
access-list 100 permit ip 10.1.1.1 0.0.0.255 host 192.168.80.19
Thanks in advance for any help
Steve
07-31-2008 03:23 AM
Steve
Is that meant to be 10.1.1.0 0.0.0.255 rather than 10.1.1.1 that you have ?
Jon
07-31-2008 03:24 AM
yeah sorry, my typo....
access-list 100 permit ip 10.1.1.0 0.0.0.255 host 192.168.80.19
07-31-2008 06:11 AM
Just to let you know that I solved the problem using route-maps....
http://www.cisco.com/en/US/docs/ios/12_2t/12_2t4/feature/guide/ftnatrt.html
Thanks
Steve
07-31-2008 07:09 AM
Steve
Thanks for posting back to the forum and indicating that you have found a solution and what the solution is. It makes the forum more useful when people can read about a problem and can read what solved the problem.
The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: