RME - Change Audit window

Answered Question

In RME change Audit Window there is a Message column. when I click on CONFIG_CHANGE title I get the following message.

DCMA0055: CM0036: The configuration file cannot be displayed as this could be a binary file.

Any ideas?

tony

I have this problem too.
0 votes
Correct Answer by Joe Clarke about 8 years 4 months ago

Known issue for vlan.dat (VLAN) config changes. You cannot view the changes in this file. You can disable tracking the vlan.dat file for changes by checking the "Enable vlan Change Audit Filter" box under RME > Admin > Change Audit > Config Change Filter.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Thu, 07/31/2008 - 08:45

Known issue for vlan.dat (VLAN) config changes. You cannot view the changes in this file. You can disable tracking the vlan.dat file for changes by checking the "Enable vlan Change Audit Filter" box under RME > Admin > Change Audit > Config Change Filter.

Actions

This Discussion