cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
525
Views
2
Helpful
2
Replies

ACS authorization problem

thetnaing00
Level 1
Level 1

hi,

i have enable the aaa command authorization tacacs+ for the ASA firewall.since i apply this, all connectiong through serial cable and telnet session go to authorize with ACS.

my question is that there is a way to enable command authorization for telnet session and NOT for serial console connection. thanks in advance.

2 Replies 2

Marwan ALshawi
VIP Alumni
VIP Alumni

then u have to use the comman

aaa authentication {telnet | ssh | http | serial} console {LOCAL |

server_group [LOCAL]}

for example:

aaa authentication telnet console [ur ACS server]

if u use ur telnet to the ASA inside interface add the following command

telnet 10.1.1.1 255.255.255.255 inside

in the above comand only host 10.1.1.1 will be permited

u can put 0.0.0.0 0.0.0.0 to permit any connection (which is not secure)

good luck

please, if helpful Rate

hi marwarishawi,

thanks for your reply. but you are talking about authentication not command authorization.i have done that authenticatin for telnet session and apply "aaa authorization command ".

the thing is authorization is appilicable to all telnet session PLUS serial console session which i don't want to get authorized.

i want serial console session to be able to use ALL commands insted of restricted. thanks again.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: