configure ssh threw ciscoworks

Unanswered Question
Jul 31st, 2008

my company has close to 100 switches and routers I need to migrate these switches and routers from using telnet withing our network to using SSH. We have cisco works 2.6 however, I'm not that familiar with it. Can I use this to push this out instead of having to do one device at a time?

thanks,

Mike

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Thu, 07/31/2008 - 21:30

Yes. You can configure a Netconfig job to push out the necessary SSH configuration to all devices at once. There is a pre-built SSH template in Netconfig to do this. Netconfig can be found under RME > Config Management.

Actions

This Discussion