08-01-2008 03:13 AM - edited 03-06-2019 12:34 AM
Hi,
I have installed a Network Analysis Module (NAM2) in a catalyst 6500.
After this I saw with "sh monitor session" a session 1 / Type Service Modul Session". Depending on this I am only able to configure two more sessions,
when I want to configure a third session for capturing traffic on the NAM I got an error message, that this is not possible. The documentation means that I can configure two span ports for traffic capturing, but depending on the first automatically created session it does not work, because all together I have three sessions. Has anyone an idea, how I can get my two session for NAM capturing and for what is the first session ?
Regards Mike
08-12-2008 04:11 AM
You can have more destinations and sources per session.
CR10#sho monitor sess 1
Session 1
---------
Type : Local Session
Source VLANs :
Both : 298
Destination Ports : Gi3/13,Gi3/16,analysis-module 9 data-port 1
CR10#sho monitor sess 2
Session 2
---------
Type : Local Session
Source VLANs :
Both : 41,300,449,651-652,701-702,708,801-802
Destination Ports : analysis-module 9 data-port 2
Hope this helps
Mats
08-14-2008 03:53 AM
Hi Mats,
thank you for your answer. I habe tried your suggestion:
sh monitor
Session 1
---------
Type : Service Module Session
Modules allowed : 1-6
Modules active : 6
BPDUs allowed : Yes
Session 66
----------
Type : Local Session
Source Ports :
Both : Gi5/1
Destination Ports : Fa3/48
RZR-E1(config)#monitor session 1 source vlan 241 both
% Session 1 used by service module
Mike
08-14-2008 05:57 AM
I have no idea about service module session!
I'm running 12.2(18)SXD7b. I think I had a session 1 when I installed the NAM in slot 9.
Mats
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: