Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

test environment setup

Unanswered Question
Aug 1st, 2008
User Badges:

We are getting ready to setup a test environment for our phone system (CCM 4.1.3 with IPCC 4.1). What I need to know is do I need to set this up completly isolated from the production environment or would I be able to use the current architecture? Basically I finished getting the new CCM and IPCC servers setup but I don't have any extra switches to plug the phones into so I'm just trying to figure out if I can use our existing switches or if I am going to have to get another switch for the test environment. If anyone has any links to setting up test environments I would be more than happy to take a look, I cannot seem to find hardly anything regarding that on Cisco's site. any other suggestions or ideas are also welcome.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Chris Deren Sat, 08/02/2008 - 11:00
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

You can absolutely use the same switch and simply place the switchports dedicated for the lab phones in a seperate VLAN, then create a seperate DHCP scope for this VLAN and point option 150 to the lab CM TFTP server. It's as simple as this.



matt_drmmer Sun, 08/03/2008 - 22:04
User Badges:

Thanks Chris - I will give it a shot in the morning and see how it goes.




This Discussion