CISCO ACS

Unanswered Question
Aug 3rd, 2008
User Badges:

Hi All


I am new to the CISCO ACS software ,at present our vpn clients are being authenticated using the cisco acs


My problem is when they get connected they are being assigned with a subnet mask and gateway can any one help me to find out where it is configured and how can it be changed .


NOTE :- there is no radius attribute IETF configured on the acs

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
lgijssel Sun, 08/03/2008 - 21:17
User Badges:
  • Red, 2250 points or more

VPN users do not necessarily receive their ip address and mask etc via radius. This may very well be performed by an ip pool on the vpn device. In that case, only the authentication would be done via ACS.

What device are you using?

Can you post the config?


regards,

Leo

muralee29477 Sun, 08/03/2008 - 21:23
User Badges:

hi leo


tks a lot for your reply ,


ok also how is the gateway ip is decided for the client


please reply



Farrukh Haroon Sun, 08/03/2008 - 23:18
User Badges:
  • Red, 2250 points or more

What is ure VPN termination device? ASA, VPNC, IOS Router?


Regards


Farrukh

muralee29477 Mon, 08/04/2008 - 00:23
User Badges:

hi I am sorry for the wrong info


it is terminating on Pix 515

Farrukh Haroon Mon, 08/04/2008 - 00:47
User Badges:
  • Red, 2250 points or more

Can you post the output of


show run vpn-addr-assign


If your Firewall is running 7.x


Regards


Farrukh

Actions

This Discussion