08-03-2008 05:59 AM
Hi All
I am new to the CISCO ACS software ,at present our vpn clients are being authenticated using the cisco acs
My problem is when they get connected they are being assigned with a subnet mask and gateway can any one help me to find out where it is configured and how can it be changed .
NOTE :- there is no radius attribute IETF configured on the acs
08-03-2008 09:17 PM
VPN users do not necessarily receive their ip address and mask etc via radius. This may very well be performed by an ip pool on the vpn device. In that case, only the authentication would be done via ACS.
What device are you using?
Can you post the config?
regards,
Leo
08-03-2008 09:23 PM
hi leo
tks a lot for your reply ,
ok also how is the gateway ip is decided for the client
please reply
08-03-2008 11:18 PM
What is ure VPN termination device? ASA, VPNC, IOS Router?
Regards
Farrukh
08-04-2008 12:02 AM
hi sir
it is cisco ios router
08-04-2008 12:23 AM
hi I am sorry for the wrong info
it is terminating on Pix 515
08-04-2008 12:47 AM
Can you post the output of
show run vpn-addr-assign
If your Firewall is running 7.x
Regards
Farrukh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: