Split tunnel / Local LAN access

astanislaus · ‎08-04-2008

What troubleshooting steps can we performed if Anyconnect Client is unable to access the Local LAN after establishing a tunnel to the ASA. Pointers to any troubleshooting URLS much appreciated.

astanislaus · ‎08-04-2008

Any Connect version 2.1

Marwan ALshawi · ‎08-04-2008

check ur split tunneling ACL

check the netbios server and dns if u are using

also make sure that have created NAT exmption also called NAT 0

with the comman

nat (inside) 0 access-list 100

where access-list 100

is an access-list matching traffic from ur LAN to the anyconnect van client pool

for example if u lan 192.168.1.0/24

and ur pool with 10.1.1.0/24

make it as follow

access-list 100 permit ip 192.168.1.0 255.255.255.0 10.1.1.0 255.255.255.0

and apply it to the nat examption (nat 0 ) as i have done above

good luck

please, if helpful Rate