POE WS-X4506-GB-T ports cannot be detected

Unanswered Question
Aug 4th, 2008
User Badges:

Hi Experts,


I have this problem here where the POE ports not able to be detected but the SX fibre able to. Example as below, when i plug the cross-cable to gi2/2 in between 2 core switches, there isn't any lights and only showing me the status below.


but gi2/6, where i use SX LC mode , it can detect.


How can i solve this prob?

Thanks in advanced.


Gi2/2 notconnect 1 full 1000 No Gbic

Gi2/6 MY000DS01 gi2/6 connected trunk full 1000 1000BaseSX

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
lgijssel Mon, 08/04/2008 - 01:22
User Badges:
  • Red, 2250 points or more

First of all, use a straight cable to interconnect two gigabit ports via UTP. The crosscable may not be compatible.

Second, what type of GBIC are you using is slot 2/2? (WS-G5483?)

In general, the GBIC should be visible when issueing a "sh interface".

Verify that the GBIC is properly seated in the slot AND that it is supported by the IOS on the switch.

Could also be a defective or counterfeit GBIC or a faulty slot on the module. Please try a different slot to reduce the possible options.


regards,

Leo

cindylee27 Mon, 08/04/2008 - 20:19
User Badges:

Thanks Leo for your reply.


Anyway, managed to solve it . Actually need to put in the command to make sure that the port is using RJ45 connection.


The command is -> media-type rj45.



Actions

This Discussion