Cisco CME Adding Didgits to the end of dialed numbers

Unanswered Question
Aug 4th, 2008
User Badges:

Greetings, i have a CCME setup running version 7.0, inbound and outbound calls are working as expected except that call setup for outbound calls can take anywhere from 5 - 15 seconds, ive spoken with a couple of people in regards to this issue as such one person mentioned adding "#" at the end of the number which set's up the call immediately.


Is there a way i can re-configure the existing outbound translation profile to add "#" at the end of every number sent to the SIP provider.


I do realise that the Interdigit timeout value can be decreased which is currently set for 6 seconds but the telephony users report that when the timeout is set for 2 - 3 seconds it is not enough time to dial a number...oh i despair!


Current config.


voice translation-rule 2

rule 1 /^999$/ /999/

rule 2 /^9\(.*\)$/ /\1/

!

voice translation-profile SIPOutbound

translate called 2

!

dial-peer voice 2 voip

description **Outbound call to SIP**

translation-profile outgoing SIPOutbound

preference 1

destination-pattern 9T

voice-class sip dtmf-relay force rtp-nte

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
DRAGI RADOVANOVIC Mon, 08/04/2008 - 06:57
User Badges:

Maybe you should be more specific with your dial peers. Create some for the 7-digit dialing (destination-pattern 9[2-9]......) one for long distance (destination-pattern 91[2-9]..[2-9]......

prefix 1)

and so on.

Your 9T pattern matches everything and relies on the interdigit timeout to call out.

Dragi

Actions

This Discussion