Need help in connecting two CMs throught pt 2pt for 4 digit dialing

Unanswered Question
Aug 4th, 2008
User Badges:

We were purchased by another company we are running 4.1 they are running 5.1 we are on 4digit ext 2200's and they are on 1700's. What do I configure to get these 2 CMs to talk to each other gateway??? Any help would be greatly appreciated.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Mon, 08/04/2008 - 18:56
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

u can do it in several ways


u can make what is called inter cluster trunk ICT which connect the two CMs directly and when u make for example a route-pattren to that company

like 1XXX

and on the gatway or route list chose the ICT u creat it which contain thier CM IP

and also they have to do the same thing on thier side in opest direction

they have to make route=pattern with 2XXX


or

u might have a gateway H323

and IP connectivity either with thier gateway or CM

make voip dial-peer point to either thier gateway if they use a gateway or directly to thier CM in this case they have to add ur H323 gateway to thier CM


for example lets say thier gateway Ip 1.1.1.1 and they need from u to dial the extentions directly without adding any more digits


on the h323 do

dial-peer voice 1 voip

destination-pattren 1...

session target ipv4:1.1.1.1


with h323 when u do this also do the following command


voice service-voip

allow connection h323-to-h323


the following link for ICT config (useful)

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094729.shtml


good luck


please Rate if helpful

Actions

This Discussion