Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
457
Views
0
Helpful
1
Replies

Catalyst 2960 not usable

ryanmepham
Level 1
Level 1

‎08-05-2008 12:47 AM - edited ‎03-06-2019 12:36 AM

I've just moved my switches onto another UPS and a couple of my 2960s are no longer working properly. In HyperTerminal, a message comes up saying "!!! WARNING: The switch is not usable !!!" Also the System and RPS LEDs are amber. If someone knows how to fix this problem, any help would be greatly appreciated

Labels:
0 Helpful
1 Reply 1

Mark Yeates
Level 7
Level 7

‎08-05-2008 05:00 AM

Ryan,

It sounds like your switch took a power surge, and it is not going to work. You should contact TAC and get this switch replaced under RMA.

Amber System LED: : System is receiving power but is not functioning properly.

Amber RPS LED: The RPS is in standby mode or in a fault condition. Press the Standby/Active button on the RPS, and the LED should turn green. If it does not, the RPS fan could have failed. Contact Cisco Systems.

Mark

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card