ok, my dial-peer are just like that, but so if this is good in configuration the mistake is in the PRI configuracion, do you know how to configure PRI services?

the fowlling things should be don regarding ur hardware moduls

so if u use wic or vwic or if its onboard or in solt one will deffer

router# clear interface s0/0/0:15

!

network-clock-participate wic 0

!

isdn switch-type primary-net5

!

interface Serial0/0/0:15

isdn switch-type primary-net5

isdn overlap-receiving

isdn incoming-voice voice

controller T1 1/0

framing esf

clock source internal

linecode b8zs

cablelength short 133

pri-group timeslots 1-24

where the :

pri-group timeslots timeslot-range [nfas_d {backup | none

| primary {nfas_int number |

nfas_group number | rlm-group number}} | service]

the follwoing link will be very helful for u

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094636.shtml

and this link to have a knowledge about hardware config

http://www.cisco.com/en/US/docs/ios/12_2t/12_2t15/feature/guide/ftbckaim.html

good luck

Please, if Hlepful Rate

Yes, I haved also reviwed that, I attach my config is like document explain, whe i try do make a call says in the ip phone something like "the number dialed cannot allow to complete the call"

Is ccm 6.x

first of all

u need to check how many digits u r forwarding

and how many digit u recieve from the gatway

u made the pots dial peer as DID

that mean the whole number will be recieved from the pstn

so is range of pstn number will be wthin

destination-pattern 605.. this one

if not

u have to either forward the full number to the CCM

and in the gateway page in CCM chose the number of digits u wanna use for internal phon

in the significant digits option

or make a translation profile on the gateway that send only 4 digits to ur CCM

so just check ur numbering paln and config