cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
479
Views
5
Helpful
1
Replies

Converting LWAP to Autonomous AP

acharyr123
Level 3
Level 3

Hi,

I have LWAP 1242-AG. I don't have WLC. I am able to login to AP via console but http access is not happening into that. AP is directly connected with switch.

I want to make it work as autonomous AP by upgrading the image.

From CLI is this possible!!

1 Accepted Solution

Accepted Solutions

andrew.prince
Level 10
Level 10

Partha,

In the below link - follow the instructions for the section "Converting a Lightweight Access Point Back to Autonomous Mode" :-

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp161272

HTH>

View solution in original post

1 Reply 1

andrew.prince
Level 10
Level 10

Partha,

In the below link - follow the instructions for the section "Converting a Lightweight Access Point Back to Autonomous Mode" :-

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp161272

HTH>

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: