FTP transfer failed when PIX failover

Unanswered Question
Aug 6th, 2008

I have 2 PIX 515E in HA. Lan based failover and stateful failover configured. If I start FTP from outside to inside and just login to the ftp server and do not do a transfer, fail a pix and there is a pause (47sec) while the secondary pix takes over but the ftp connection stays active and I do not have to login again. However if I have an ftp transfer running and fail a pix you get a netout:connection reset by peer and you lose the ftp connection and have to login again. I was expecting the transfer to pause while secondary pix takes over and then continue. Anyone now why its not doing that?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion