Near side
Fax connected to ATA setup for passthrough mode > callamanger 6.1 > h323 gateway > WAN
Far side
FAX > connected to PBX > h323 gateway WAN
What is the recommended setup when the near side is all Cisco VOIP but the far side is a PBX with faxes behine the far side cisco h323 gateway?
I can send faxes to far side but far side can't send to me. Show connection, but fax doesn't complete from far side to near side.
On Near side I have modem passthrough on outbound dial-peers to far side as well as dial-peer pointing to callmangarATA. Codec is g711ulaw and fax rate disabled.
On far side I have modem-passthrough set for outbound voip dial-peer, fax rate disabled and g711ulaw as codec.
Your help is appreciated.
thanks