08-06-2008 02:31 PM - edited 03-17-2019 09:27 PM
I just go a cisco 2801 and would like to set a small CCME lab.
what will I need to get to make it into a CCME router?
the IOS and PVDM????
Thanks
08-07-2008 07:45 PM
only IOS enough
PVDM used with its DSPs for transcoding MTP and conferenceing resources
if u wanna do like confrenceing
u need DSP resources
each confrence need DSP
but for nromal CME without PVDM u can practce alot of features and u can say most of the features
good luck with ur lab
please, if helful rate
08-08-2008 10:56 AM
Cisco IOS Versions 12.4.15T4 through 12.4.15T6 being the lastest. Use the archive command to place the CCME html files in FLASH:/GUI.
If you only plan to use SCCP Cisco phone or the Cisco IP softphone no PVDM is required. If you plan on using mulitple voice protocols then you'll need it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: