There were problems with the configuration of static nat with the route-map and dynamic translation.
There is such a configuration:
ip nat inside source static 172.21.34.118 10.205.6.12 route-map net10
ip nat inside source static 172.21.34.118 172.24.172.6 route-map net172
ip nat inside source static 172.21.34.117 10.205.6.11 route-map net10
ip nat inside source static 172.21.34.117 172.24.172.5 route-map net172
access-list 101 permit ip 172.21.34.0 0.0.0.255 172.24.172.0 0.0.0.255
access-list 102 permit ip 172.21.34.0 0.0.0.255 10.200.4.0 0.0.0.255
route-map net172 permit 10
match ip address 101
route-map net10 permit 10
match ip address 102
works as I need.
Now there was a need addresses from the network to broadcast 172.21.34.0/24 dynamically to the interface.
ip access-list extended ACL_NAT_TEC
permit ip 172.21.34.0 0.0.0.255 172.24.172.208 0.0.0.7
ip nat inside source list ACL_NAT_TEC interface Serial1 / 1:0 overload
Ceases to operate static translation, addresses 172.21.34.117 and 172.21.34.118 translate to the interface address. What could be a problem. I want to work together and static and dynamic nat.
Thanks in advance.