tstanik Tue, 08/12/2008 - 06:02

You can use this command To set the differentiated services code point (DSCP) value in the tunnel header of a Layer 2 Tunnel Protocol Version 3 (L2TPv3) tunneled packet for tunnel marking, use the set ip dscp tunnel command in policy-map class configuration mode. To disable this functionality, use the no form of this command.

set ip dscp tunnel dscp-value

no set ip dscp tunnel dscp-value


where dscp value is number from 0 to 63 that identifies the tunnel header value. The following reserved keywords can be specified instead of numeric values:

EF (expedited forwarding)

AF11 (assured forwarding class AF11)

Actions

This Discussion