Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1041
Views
0
Helpful
3
Replies

l2tp qos marking

dragec
Level 1
Level 1

‎08-06-2008 10:43 PM - edited ‎03-03-2019 11:03 PM

why I cannot use set ip dscp tunnel command in my qos packet marking for xconnect session? I do not have this command and ios is c7200-ik9o3s-mz.124-21.bin.

Labels:
0 Helpful
3 Replies 3

dragec
Level 1
Level 1

‎08-12-2008 03:25 AM

nobody?

0 Helpful

tstanik
Level 5
Level 5

‎08-12-2008 06:02 AM

You can use this command To set the differentiated services code point (DSCP) value in the tunnel header of a Layer 2 Tunnel Protocol Version 3 (L2TPv3) tunneled packet for tunnel marking, use the set ip dscp tunnel command in policy-map class configuration mode. To disable this functionality, use the no form of this command.

set ip dscp tunnel dscp-value

no set ip dscp tunnel dscp-value

where dscp value is number from 0 to 63 that identifies the tunnel header value. The following reserved keywords can be specified instead of numeric values:

EF (expedited forwarding)

AF11 (assured forwarding class AF11)

0 Helpful

dragec
Level 1
Level 1
In response to tstanik

‎08-12-2008 06:25 AM

there is no such command

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card