cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
281
Views
0
Helpful
2
Replies

6509 with SUP2 problem

sooner600
Level 1
Level 1

I have a client that purchased a SUP2 w/ MSFC2 and a 6509 chassis. He is complaining of very long load times for the show run and write memory commands. This begins several hours after reload. I told him to eliminate the flash and RAM as the culprit by process of elimination. I was wondering if anyone had seen symptoms like this before. He is running IOS (tm) c6sup2_rp Software (c6sup2_rp-PK9SV-M), Version 12.2(18)SXD6. Thank You.

Will

2 Replies 2

Jerry Ye
Cisco Employee
Cisco Employee

Hi Will,

It is really depend on how big is the config and how busy is the CPU. If you have a really large config, "show run" will take some time. Same thing apply to a really busy switch.

You can verify it with "show proc cpu" and "show run | i bytes".

HTH,

jerry

Thank you Jerry.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: