08-07-2008 09:56 AM - edited 03-03-2019 11:04 PM
Hi,
I want to connect my Cisco 2801 (C2801-ADVIPSERVICESK9-M) an E1, do you know the part number for WIC modules for 2801 routers ?.
Best regards, thank you.
Solved! Go to Solution.
08-08-2008 10:18 AM
RJ-48 to BNC?
Well, then the BNC will go to the telco side and the RJ-48 will connect to this unit:
VWIC-1MFT-E1
http://www.cisco.com/en/US/prod/collateral/routers/ps274/product_data_sheet09186a0080091b9c_ps259_Products_Data_Sheet.html
HTH,
__
Edison.
View solution in original post
08-07-2008 10:24 AM
VWIC2-1MFT-T1/E1
http://www.cisco.com/en/US/prod/collateral/routers/ps5855/product_data_sheet0900aecd8028d2db.html
08-08-2008 08:21 AM
Thanks Edison,
Do you know If there is another type of WIC, because my ISP is going to give me a V35 interface, I need a serial port.
Do you understand me ?.
Thank you, best regards.
08-08-2008 08:56 AM
HWIC-4T
http://www.cisco.com/en/US/prod/collateral/modules/ps5949/ps6182/product_data_sheet0900aecd80274416.html
Please rate helpful posts
08-08-2008 09:29 AM
Edison,
Do you know the part number for the RJ-48 cable of VWIC2-1MFT-T1/E1 ?.
Thank you.
08-08-2008 09:50 AM
RJ-48?
I've always used the standard patch cable on those kind of connections. From the WIC to the telco jack.
08-08-2008 10:00 AM
Yes, do you have this standard patch cable part number ?. is there ?.
08-08-2008 10:03 AM
There isn't a part number. You can find that kind of cable basically anywhere. It's the same cable you would use to connect your PC to a network jack.
08-08-2008 10:06 AM
Ok, I understand you, but I receive from ISP a coaxial cable with BNC connector, do you understand me ?.
Ther is a cable with Rj-48 to BNC for this connection.
08-08-2008 10:35 AM
Thank you !
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
