Enable outbound caller-id individually

Unanswered Question
Aug 7th, 2008

I have outbound caller id blocked for the entire organization and I wondered if it was possible to enable it for one individual user.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Jaime Valencia Thu, 08/07/2008 - 12:38

where do you have it blocked???? you don't say that



if this helps, please rate

houstonrob Thu, 08/07/2008 - 12:40

Route pattern

Calling line id presentation: restricted

Calling name presentation: restricted

Can i block it elsewhere instead that would allow me to accomplish what i want?

Jaime Valencia Thu, 08/07/2008 - 13:05

easiest way would be to configure a route pattern 9.@ and that only that particular user could reach it

otherwise you would need to create a copy of each route pattern and have it on a partition that only that user can use



if this helps, please rate

vpreenja Thu, 08/07/2008 - 20:26

If you are not using any " calling party mask" at the route pattern or route list , you can apply a fake " External mask" at the device level for the devices whose caller id you want to block.

Check " use calling party mask" at the route pattern .

houstonrob Fri, 08/08/2008 - 12:04

Thanks for the ideas, I'll try them out and see what works best for us.



This Discussion