WCS and Heat Maps

Unanswered Question
Aug 8th, 2008

I'm having trouble understanding how to set antenna orientation.

We have an outdoor mesh consisting of 1500's. When I add APs to a WCS outdoor map and attempt to set the antenna azimuth and elevation the resultant heat maps don't look right...

The antennas are mounted to a pole 65' in the air with both antennas pointed at the ground.

Any recommendations on how to set azimuth and elevation ?


dave moreland

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dmorelan Fri, 08/08/2008 - 06:44

So, if I understand, the azimuth should be set to 0 degrees for an omni (this is confirmed in the release notes as well).

I'm still having trouble with the elevation; 0-180 degrees, either up or down. Can you recommend settings for an AP, 65 from the ground on a pole with the antennas pointed at the ground ?


This Discussion



Trending Topics - Security & Network