Incoming calls on FXO interface

Dirk Woellhaf · ‎08-08-2008

Hello,

following situation:

I have a 2600XM running CME 3.3 on it, with a VIC-2FXO-EU. I'm able to make outgoing calls to the POTS, but not able to take calls from the POTS. Infrastucture looks like this:

POTS <---> PBX <---> 2600XM <---> IP network

Any ideas on this?

regards Dirk

regards, Dirk (Please rate if helpful)

jbarcena · ‎08-08-2008

you only need a pots dial-peer, something like this:

dial-peer voice 40 pots

description ***** FXS *****

destination-pattern 9788587772

port 0/0/1

Dirk Woellhaf · ‎08-08-2008

Hi,

there is no FXS interaface on the "inside". Running Cisco's Ip Communicator on my ip network

regards, Dirk (Please rate if helpful)