That works, but i can't ping vlan 60 from the router or a switch that is trunked to that switch.

Router_Elm#ping

Protocol [ip]:

Target IP address: 10.2.0.2

Repeat count [5]:

Datagram size [100]:

Timeout in seconds [2]:

Extended commands [n]: y

Source address or interface: 10.2.0.1

Type of service [0]:

Set DF bit in IP header? [no]:

Validate reply data? [no]:

Data pattern [0xABCD]:

Loose, Strict, Record, Timestamp, Verbose[none]:

Sweep range of sizes [n]:

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.2.0.2, timeout is 2 seconds:

.!!!!

Success rate is 80 percent (4/5), round-trip min/avg/max = 1/1/4 ms

Router_Elm#ping 10.2.0.2

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.2.0.2, timeout is 2 seconds:

.....

Success rate is 0 percent (0/5)

switch-elm-idf-a#ping 10.2.60.1

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.2.60.1, timeout is 2 seconds:

.....

Success rate is 0 percent (0/5)

Edison,

Thanks alot.... I enalbed the routing protocol on the router and also had to create a static route to 10.2.0.1 on the switch.

Gateway of last resort is 10.2.0.1 to network 0.0.0.0

10.0.0.0/24 is subnetted, 5 subnets

C 10.2.0.0 is directly connected, Vlan1

C 10.2.60.0 is directly connected, Vlan60

C 10.2.70.0 is directly connected, Vlan70

C 10.2.90.0 is directly connected, Vlan90

C 10.2.80.0 is directly connected, Vlan80

S* 0.0.0.0/0 [1/0] via 10.2.0.1