08-10-2008 12:13 PM - edited 03-13-2019 05:33 PM
hi all,
I have a CME version 4.1(0) on 2821 router with IOS 12.4(15)T5.
i configured the following dial-peer:
dial-peer voice 15 pots
service aa
destination-pattern 8...
port 0/2/1
and when i try to call 8320 i get a fast busy tone
i tried csim start command with debug voice ccapi inout and get the messages shown in the attachment.
Note: the service aa command under the dial peer is used for auto attendant purpose.
could any one please help me to know the reason of this?
thanks
08-10-2008 09:53 PM
csim start should not be used for any real testing, it can cause wierd things for wierd reasons, and I have proved csim start to be the only cause of my problems many times. Try it from a phone then resend everything if it still fails...
HTH,
Chad
08-10-2008 09:56 PM
Also if you tried it from a phone, was it an ip phone? I don't believe you can have that work like you want it to, unless it pots incoming dial peer. try
dial-peer peer voice 15 voip
incoming called-number 8320
session target ipv4:
codec g711ulaw
no vad
Cheers,
Chad
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: