08-11-2008 03:20 AM - edited 03-06-2019 12:43 AM
I have uploaded a new IOS on a 3750 stack. Stack consists of two switches, a master and a member.
I have configured the master's boot path with a newaly extracted IOS. But the thing is that the member switch is still configured with an old path and I can not change it. Will master switch upgrade the stack member after reload? Is there any way to manually configure member switch with a new boot path?
BOOT path-list : flash2:/c3750-advipservicesk9-tar.122-44.SE2/c3750-advips
rvicesk9-tar.122-44.SE2.bin
Config file : flash:/config.text
Private Config file : flash:/private-config.text
Enable Break : no
Manual Boot : no
HELPER path-list :
Auto upgrade : yes
-------------------
Switch 2
-------------------
BOOT path-list : flash:c3750-ipbase-mz.122-25.SEE3/c3750-ipbase-mz.122-25.
EE3.bin
Config file : flash:/config.text
Private Config file : flash:/private-config.text
Enable Break : no
Manual Boot : no
HELPER path-list :
Auto upgrade : no
Solved! Go to Solution.
08-11-2008 04:47 AM
I think auto upgrade is disable on switch 2, refer following link for IOS upgradation of stack.
08-11-2008 04:47 AM
I think auto upgrade is disable on switch 2, refer following link for IOS upgradation of stack.
08-11-2008 06:08 AM
Thank you
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: