I have a NetShow job that is failing with this message:
ERROR:RME_CDL1031:Transport session to device failed Unable to enter ENABLE mode from USER mode Unable to enter ENABLE mode from USER mode
I have double checked the credentials in DCR and I am able to successfully use the same ones going directly to the device. Also these are only SHOW commands so I don't know why they require enable mode. Thanks.
You can get access to the output using cwcli:
cwcli netshow jobresults -u admin -p admin -id 1358 -output netshow_1358.txt
Two things. One, "show modules" is not a valid IOS command. Two, you separated your commands with a newline instead of a comma. When entering Netshow custom commands, they must be comma-separated. Try the following:
show ver,show running-config,show access-lists