08-12-2008 07:37 AM - edited 03-03-2019 11:07 PM
Hi,
I am upgrading my sup32 from Hyrbrid to native, and am following the guide:
When i issue the reload command after changing the config register value to 0x0 i get the following message:
Reload to tge ROM Monitor only allowed from console line unless the conf register boot bits are non zero.
How do I get the router to reload in monitor mode?
Help well rated
08-12-2008 07:49 AM
put confreg 0x2102
or use break sequence for rommon and put confreg 0x2102
--
Regards,
Raul
(Please rate helpful posts)
08-12-2008 07:56 AM
I did this and it broke out of session 16
now I can't get on to the MSFC at all
when I do session 16 I get unable to tunnel to session 16
Am i in big trouble now?
08-12-2008 10:29 AM
enter from console of msfc and review your config.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: