08-12-2008 07:37 AM - edited 03-03-2019 11:07 PM
Hi,
I am upgrading my sup32 from Hyrbrid to native, and am following the guide:
When i issue the reload command after changing the config register value to 0x0 i get the following message:
Reload to tge ROM Monitor only allowed from console line unless the conf register boot bits are non zero.
How do I get the router to reload in monitor mode?
Help well rated
08-12-2008 07:49 AM
put confreg 0x2102
or use break sequence for rommon and put confreg 0x2102
--
Regards,
Raul
(Please rate helpful posts)
08-12-2008 07:56 AM
I did this and it broke out of session 16
now I can't get on to the MSFC at all
when I do session 16 I get unable to tunnel to session 16
Am i in big trouble now?
08-12-2008 10:29 AM
enter from console of msfc and review your config.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide