catalyst Ws-C6500-L

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Tue, 08/12/2008 - 10:46
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Frank,

try to use the following command


conf t

power enable module


this should provide power to the module in slot slot_number


Hope to help

Giuseppe



Giuseppe Larosa Wed, 08/13/2008 - 04:38
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Franck,

sorry it was even easier ...


when you add a network module in a never used slot you need to enable the new module's ports with no shut on all the ports you want to use


do

int gi7/1

no sh


to get at least a L1 link


Hope to help

Giuseppe

Giuseppe Larosa Wed, 08/13/2008 - 08:21
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Franck

in order to connect a PC and to provide ip connectivity:


you need to put the port in switchport mode and in an access vlan that has L3 services:


int gi7/1

no shut

>>switchport

switchport mode access

swtichport access vlan 130


Be aware in a C6500 default port config is to be a routed port (to have an ip address on it).


This is a different behaviour then other multilayer switches where the port is L2 by default.


you can check with:


sh int gi7/1 switchport


where 130 stays for an access vlan

or also vlan 1 can be used of course



Hope to help

Giuseppe

Actions

This Discussion