08-13-2008 12:30 AM
I am unable to login to my express setup on my 3750G 10.0.0.1
I have done everything?
I have also factory rebooted my switch
It has IOS 12.2
08-17-2008 01:09 PM
Dan,
I suggest you follow the below instructions:-
HTH>
08-17-2008 09:49 PM
check out the express setup is enabled on your switch. by default it is enabled.
Check out if this link can help you out.
08-20-2008 11:17 AM
In a recent project that I am doing I have 2 cisco 3750G switches straight out of the box, two TFOCA boxes, two SX-MM, two Orange fiber patch cables and two yellow fiber patch cables.
Now the setup that i have looks kinda like this:
Switch1 --- Gbic --- Orange fiber -- TFOCA --Tactical Fiber -- TFOCA --- Orange fiber --- Gbic --- Switch2
192.168.1.2 /24 192.168.1.3 /24
Each GBIC is plugged into G1/0 which is the GBIC slot on both switches. I have each port set to Trunking:
sw trunk encap dot1q
sw mode trunk
no shut
When I go to each switch and type show cdp neigh I see the other switch on both switches. But when I go into Switch 1 and try to ping the other switch it goes through, but when I go into switch 2 I cannot ping the other. I know its a simple problem, but for some reason I cannot get it to work. here is the trouble shooting that I have done below:
Traded out the orange fiber patch cable with the yellow.
Light test on all Fiber which went though.
Traded out GBICS
Traded out multiple Orange/yellow fiber patch cables.
swapped TX to RX on one switch at a time.
Swapped GBIC slots on both Switches
With my knowledge I have troubleshooted as much as I know, but still cannot get Switch 2 to talk to Switch1. its something simple that I'm overlooking, but I have no idea what it is.
More info in spanish go to my articles site on
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: