Login softkey in IPphones

Unanswered Question
Aug 13th, 2008
User Badges:


I am configuring Call-Block patterns in CME4.3 with 7911 and 7941 phonnes

The problem is that the login softkey does not appear ine the phones for call-block overriding

Some one can tell me what can I do to make the phone display that softkey.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jaime Valencia Wed, 08/13/2008 - 08:59
User Badges:
  • Cisco Employee,
  • Hall of Fame,


configure the ephone-template and assign the softkey to onhook state, then apply it to the ephones



if this helps, please rate

abdeljaoued Wed, 08/13/2008 - 09:34
User Badges:

I configured the ephone-template with the "softkeys idle login" command and it does not work (only non configurable keys are displayed).

I dont know how to assign the softkey to onhook state. Normally the login key work in the idle state of the phone no?

rfovrtega Fri, 11/07/2008 - 17:10
User Badges:

I'm having trouble about it too, and here's what I've done to make the login softkey active.

1. Make sure that the login softkey is activated in your ephone-template under idle state.

e.g. ephone-template 1

softkey idle Newcall Login

2. Make sure that the particular ephone you what to be login has a pin.

e.g. ephone 3

pin 1234

3. Finally, the most important thing, and also I overlooked that's why we cannot activate the login key is that we should put a login timeout under telephony services.

e.g. telephony services

login timeout 240


This Discussion