ACS/ LEAP and 7921G

Unanswered Question
Aug 13th, 2008
User Badges:

Hello,


I am having issues with our 7921G's authenticating through our ACS. I am using WCS to control two WiSM controllers. Currently, the SSID is set up to use WPA+WPA2 (AES and CCKM). The AAA settings point to our ACS server and I have LEAP authentication enabled and pointing to a profile. I have the phones configured with the same profile information but in ACS I get and error saying " EAP type not configured". I have gone through the phone and reset all passwords and verified the SSID. Can anyone advise on what to (re)check or where to look?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Wed, 08/13/2008 - 13:05
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

When you get that error on the ACS, it usually means that you didn't configure that EAP type the phones are using on the ACS itself. Try to get a laptop associated and authenticated first, before you try it on the phones.

Actions

This Discussion

 

 

Trending Topics - Security & Network